Our partner
Cryogenic Accessories
From Lake Shore CryotronicsTo contact heaters and sensors in a low temperature environment, it is important to use special materials suitable for these temperatures. Good electrical conductivity paired with poor thermal conductivity materials are here the materials of choice, like phosphor-bronze. Also, other cryogenic and temperature measurement accessories could be found here, including cable, wire, solder, heaters, insulating and conductive materials.
- Cryogenic wires and cables
- Solder for cryogenic application
- Epoxy and grease for low temperatures
- Superinsulation, vacuum feedthroughs, cartridge heaters
Further information
- Single strand cryogenic wire — WSL-32, WSL-36
- Twisted lead wire — WCT-34
- Duo-Twist™ cryogenic wire — WDT-32, WDT-36
- Quad-Lead™ cryogenic wire — WQL-32, WQL-36
- Quad-Twist™ cryogenic wire — WQT-32, WQT-36
- Manganin wire — WMW-30 , WMW-32, WMW-36
- Heavy duty lead wire — WHD-30
- Nichrome heater wire — WNC-32
- Ultra miniature coaxial cable — type C, SC, SS
- Semi-rigid coaxial cable — type SR
- CryoCable™ — type CRYC
- Indium foil/solder
- High temperature solder
- Ostalloy® 158 solder
- Low temperature conductive epoxy
- Stycast® Epoxy 2850-FT, Catalyst 9
- Apiezon® Grease—types N and H
- Heat sink bobbins
- Beryllium oxide heat sink chip
- Superinsulation
- 19-pin vacuum feedthrough
- 4-lead resistance sample holder
- Cartridge heaters
- Electric tape for use at cryogenic temperatures
- Ferrite bead for high frequency filtering
Specifications
Downloads
Contact
Staffan
Eriksson
Navigation
Categories
Contact
Quantum Design GmbH
Roddarestigen 3
SE 182 35 Danderyd
Sweden
| Phone: | +46 8 41071791 |
| E-mail: | nordicqd-europe.com |
