Analizzatore di spettro per laser CO2
da MackenL’analizzatore di spettro per laser CO2 è uno spettroscopio a singolo reticolo che visualizza simultaneamente tutte le linee rotazionali delle transizioni vibrazionali di un laser CO2.
Lo strumento è calibrato sia in lunghezza d’onda che con linea rotazionale assegnata per consentire la facile identificazione di oltre 140 possibili transizioni tra 9.1µm e 11.3µm.
Tali transizioni sono visualizzate illuminando mediante radiazione UV uno schermo termo-sensibile che si scurisce nell’area colpita dal fascio laser IR. Lo schermo dello Spectrum Analyzer ha un tempo di risposta di ¼ di secondo e permette allo strumento di risolvere tutte le linee rotazionali.
Il modello 16-A è leggero, portatile e può essere facilmente inserito in setup sperimentali.
Caratteristiche
- Visualizzazione a schermo della lunghezza donda del laser
- Range di lunghezza donda: da 9.1µm a 11.3µm
- Identificazione di oltre 140 linee rotazionali
Maggiori informazioni
Wavelength Scale
This is a portion of the wavelength scale shown at full size. The upper calibrations are CO2 rotational line designations and the lower scale is the wavelength in microns. The thermal sensitive screen in the center displays the lasing wavelengths as a dark line.
The wide sensitivity range of the spectrum analysis screen can simultaneously display lines which differ in power density by a factor of 20. Each instrument is factory calibrated and should never need adjustment. However, a simple procedure allows the calibration to be checked by the user.
During operations, the laser beam is allowed to strike the front of the Spectrum Analyzer so that a portion of the beam passes through a variable slit. Normally the laser beam is intense enough that it is not necessary to focus the light on the slit. The light which does not pass through the slit is absorbed in the matte anodized case.
The internal beam monitor is a Thermal Imaging Plate that displays the CO2 laser beam which has passed through the slit. During the positioning of the instrument this device is engaged. When the monitor indicates the Analyzer to be properly positioned, it is then disengaged to allow the beam to pass onto the display screen.
Specifiche
Specifications Model 16A | |
---|---|
Wavelength Range | 9.1 to 11.3 µm |
Resolution | 0.003 µm (0.3 cm-1) |
Maximum Power | 100 watts |
Minimum Power (focused) | 0.01 watts |
Screen Response Time | 25 sec |
Length | 45,7 cm |
Width | 25,2 cm |
Minimum Height | 16,5 cm |
Elevation of Slit | 5,7 to 9,7 cm (adjustable) |
Electrical Power | 230 V, 50 HZ, 10 watts |
12C16O2 Vibrational-Rotational Lines Identified | 0001 - 0200 P2 to P60 & R2 to R62 0001 - 1000 P2 to P56 & R2 to R60 0111 - 1110 P19 to P45 |
Contatti

Ing.
Alessandro
Baratti
Navigazione
Categorie
Contatti
Quantum Design s.r.l.
Via Francesco Sapori, 27
00143 Roma
Italy
Telefono: | +39 06 5004204 |
Fax: | +39 06 5010389 |
E-mail: | italyqd-europe.com |